Well that's another 2 hours wasted on an EvoHome error.
Is it me or EvoHome?
I still have one or two HR80 actuators on my system and I decided to change them to HR92s. Simple eh?
It all seemed to go OK but later in the evening I saw a the red triangle next to my Kitchen zone on the Evotouch.
Evotouch and the actuator are only six feet apart so I knew I had good signal strength.
I deleted the Kitchen zone and re-binded - no change. I tried another actuator - the red triangle was still there! Huh?
Everything was working fine except for the red symbol being present.
It wasn't until I ran a signal strength check - putting the actuator into Checking mode and ran Check from Evotouch that I noticed the red error symbol had disappeared.
Does it say anywhere in any of the documentation that to clear the red comms error symbol you need to run a strength test?
Is it me or Evohome?
Chris
Is it me or EvoHome?
I still have one or two HR80 actuators on my system and I decided to change them to HR92s. Simple eh?
It all seemed to go OK but later in the evening I saw a the red triangle next to my Kitchen zone on the Evotouch.
Evotouch and the actuator are only six feet apart so I knew I had good signal strength.
I deleted the Kitchen zone and re-binded - no change. I tried another actuator - the red triangle was still there! Huh?
Everything was working fine except for the red symbol being present.
It wasn't until I ran a signal strength check - putting the actuator into Checking mode and ran Check from Evotouch that I noticed the red error symbol had disappeared.
Does it say anywhere in any of the documentation that to clear the red comms error symbol you need to run a strength test?
Is it me or Evohome?
Chris