Temperature displayed on HR92 with evotouch controller as a sensor

Hi,

i have zone configured with two valves HR92 and evotouch controller acting as temp sensor for this zone.
i configured valves to display current temp reading rather than setpoint - "avanced" configuration in HR92 allows you to do so - option "7", value "1".


do I understand it correctly that for evotouch being zone thermometer both HR92s should display what is coming from evotouch?

example:

first HR92 - reads temp1
second HR92 - reads temp2
evotouch reads temp3

ALL three show zone temp of temp3

?
and of course - in most cases these three should be close if not even identical. but its more about getting clear whats the design here?