Over the past day or two I've got a new Evohome system up and running for control of my radiators. I'm now turning my attention to the installation of the Evohome Hot Water Kit.
One problem has arisen in the early stages of this process. I want to connect the two-wire cable from the cylinder thermostat to the back of the CS92 transceiver, but I'm struggling to separate the two halves of the transceiver to expose the terminal screws. Is there a trick to do this without damaging the box?
One problem has arisen in the early stages of this process. I want to connect the two-wire cable from the cylinder thermostat to the back of the CS92 transceiver, but I'm struggling to separate the two halves of the transceiver to expose the terminal screws. Is there a trick to do this without damaging the box?