HR92 Comms Fault/Binding Issue?

Hi,

So I have a Comms Actuator fault appearing on the evohome controller following some reconfiguration I recently did to a zone. I had a zone called ‘Kids Zone’ which was made up of 2 bedrooms and a bathroom. Each room had one radiator and one HR92. I then reconfigured one of the bedroom into an office so needed a new heating schedule for the office. I unbound the HR92 from the Kids Zone and this procedure worked well. I then created a new zone on the Evohome controller called Office and bound the HR92 to this zone. This process worked (as far as I could tell) and is working independently now from Kids Zone. However I keep getting a Comms fault (daily) on the Office zone and am not sure what I’ve missed in the above process or how to resolve it. The lead HR92 in the Kids Zone was not this HR92.

Any ideas?

Thanks,

Richard